2
For technical support contact Yale
®
at 800.438.1951
An ASSA ABLOY Group brand
Copyright © 2019, ASSA ABLOY Access and Egress Hardware Group, Inc.
All rights reserved. Reproduction in whole or in part without the express written permission
of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
80-9303-3207-010 Rev 1 05/19
Use provided hex wrench to turn valves.
NEVER force valves out of closer. NEVER
completely close backcheck valve.
Door must be open to adjust spring
closing power. Refer to chart.
Do not use
a power drill. Warranty will be void.
•
“DA” suffix (Delayed Action) is an optional feature.
• For special applications, a separate door and frame
preparation template is packed with these instructions. Use
this instruction sheet for installation sequence and closer
adjustments only.
• Doors should be hung on ball bearing or anti-friction hinges.
Mounting Hardware
Door or Frame
Drill
Closer, H/O Shoe or Optional PA Bracket:
1/4-14 x 1-1/2 Oval Flat Head Mach. Screw
Wood
3/16" (4.76mm)
Closer, H/O Shoe or Optional PA Bracket:
1/4-20 x 3/4 Oval Flat Head Mach. Screw
Metal
Drill #7 (.201 dia. or 5.10mm)
Tap 1/4-20
H/O Shoe to Optional PA Bracket:
1/4-20 x 1/2 Oval Flat Head Mach. Screw
Closer:
Sleeve Nut and Bolt (SNB)
(optional)
Hollow Metal
9/32" (7.00mm) thru
3/8" (9.50mm) door face opposite to closer
Aluminum or Wood
3/8" (9.50mm) thru
Closer:
Thru Bolt and Grommet Nut (TBGN)
(optional)
All
9/32" (7.00mm) thru
3/8" (9.50mm) dia. x 3/8" (9.500mm) deep,
door face opposite to closer
• A separate door stop is recommended.
• Always consult door/frame manufacturer for fastener compatibility.
• Door and frame must be properly reinforced.
•
Adjust closing time speed between 3 and 7 seconds from 90° to 0°.
Greater closing times may be required for elderly or handicapped.
• These door closers should NOT be installed on exposed side
(weather side) of exterior doors.
•
Dimensions are given in inches (millimeters).
ATTENTION:
An incorrectly installed or improperly adjusted door closer can
cause property damage or personal injury. These installation
instructions should be followed to avoid the possibility of
misapplication or misadjustment.
Closer Adjustments
Do not over tighten
cap or cover screws.
Pinion Cap and Cover
Latch
Backcheck
Sweep
Architectural (“A”) covers
cannot be used on parallel
mounted closers with doors
swinging over 120°.
Regular Arm
Top Jamb Mount
Parallel Arm
Optional
Delayed Action
Before You Begin
3000 Installation
Instructions
