Yale Smart Living HSA6210-R, Installation, Programming, Operating, Page: 3 / 16

3
Unpack all the parts
2
External Siren HSA6050
The Siren comes in two shapes, square shaped
and round depending on the kit purchased. The
operation and programming of the Sirens are
identical, only the case is different.
WARNING
The Siren is very loud, be prepared! Take care not to
activate the Siren tamper switch unnecessarily.
1
Remove the cover by unscrewing the single screw
located on the lid.
2 Square siren only: remove the left hand cover (not
battery compartment).
3 Move the programming switches
to Master On (switch 4) and Clear
On (switch 1).
4 Switch the power switch to on
(The 3 strobe LEDs will now flash side to side with one short
beep.)
5 Move the Clear switch to the Off
position.
PIR Motion Detector HSA6020
1 Pull out the plastic pull tab on the back of the PIR.
This will activate the batteries.
(A red light can be seen flashing through the lens. This will last
for 30 seconds indicating the component’s initiation. )
O
N
1
2
3
4
Clear
O
N
1
2
3
4
Normal Master
Cover screw
Learn/Test
Button
Status
LED
NORMAL