Product diagram
Battery installation
The battery compartment is located on the rear of the alarm
unit. It can be accessed by removing the screw from the
back of the unit and lifting the cover
Insert 4 ‘AA’ Alkaline size batteries (not included) as shown
(diagram). When the last battery is inserted the centre red
LED will flash 3 times. Replace the back cover and fix with
screw.
NOTE:
Please wait 30 seconds before inserting new
batteries whenever you take old batteries out.
1.
Front ‘eyebrow’ contacts
2.
Contact Sensor & Magnet
3.
LED x 3
4.
ArM & CLr buttons
5.
1, 2, 3 & Yale buttons
6.
Siren
1
2
3
ARM
CLR
1.
Battery compartment
2.
reset button
3.
rear contact points
Installing the unit
Place the alarm in the desired location, preferably on the
door or window, using the screws or adhesive Velcro tape
supplied.
The magnetic contact must be aligned to the same level,
next to the alarm so that contact can be made when the
door is closed.
Operation
Leaving the protected area
Press the ARM button on the unit
The Red LED will quickly flash to confirm the unit is armed.
You have 20 seconds to vacate the area.
During this period, 5 count down beeps (with 5 single Green
LED flashes) will sound to warn of the exit period.
Entering the protected area
Within 10 seconds of entering type in your 4 digit PIN code
and press CLR. The red LED will flash quickly and the unit
will beep once to confirm the unit is disarmed.
NOTE:
If PIN entered incorrectly 5 times, unit will beep
10 times and the unit will ‘sleeps’ (not do anything e.g.
keypad locked) for 5 mins. Unit continues in whatever
mode it was in prior (e.g. siren sounding)
Alarm activated
If the unit is activated the siren will sound for 2 minutes.
The orange LED will also flash (this is to show which unit
has been triggered, if you have more than one device set
up to work together).
Care and maintenance
To clean the unit, simply use a soft, slightly damp with
water, cloth and wipe dry immediately.
Caution: Never use chemicals to clean the unit as this may
cause damage to the plastic and result in the alarm not
functioning.
Front
Back
Setting the PIN code
In order to use the unit you must set a 4 digit PIN code,
using the buttons 1, 2, 3, Yale. The default setting of this is
1, 2, 3, Yale. To change this;
1.
Enter the current PIN (default set to 1, 2, 3, Yale)
2.
Press CLR (the orange LED will be on for 3 seconds)
3.
Enter the new PIN code
4.
Enter old PIN and press CLR.
5.
The orange LED will flash 3 times to confirm
6.
The unit will return to disarm mode.(red LED will flash 3
times)
For security reasons, if a
delay of more than 5 seconds
occurs between any of the
above steps (all LEDs will flash
3 times, and the unit will beep
to confirm an error) the unit will
return to disarm mode.
1
2
3
ARM
CLR