Page 3
80-9344-0705-010 (7-01)
7.
ith spring adjustment nut toward lock edge of door
and closer valves:
Facing
for
door
Facing
for
door
8.
and install 9/64" hex drive socket
head screw from screw pack.
9.
using Arm Indexing
instructions above.
10.
11.
in track assembly. Secure by
pushing in on the retainer clip that extends from the slide block
in the track, until it is flush with the slide block.
w
1.
Locate and drill 1-1/8" (29mm) diameter hole in frame soffit
for the conduit.
2.
using above
template:
holes for
or
holes for
.
holes for
3.
using "Preparation for
Fasteners" chart above.
4.
with smoke detector
toward lock edge of frame and open side facing down.
5.
from hook-up box assy.
6.
with
conduit hole openings away from hinge edge of frame.
Place Hook-Up Box straps between frame and
chassis. Special conduit nut supplied to anchor 3/4"
conduit fitting.
Units with a 120V to 24V transformer require that
hook-up board be removed from chassis to enable
mounting.
Opening
Metal Frame
Metal
Door or Frame
Wood or
Composite
Door
Fasteners
8-32 Machine Screw
1/4-20 Machine Screw
3/8 Dia. Sex Nut
Fastener Preparation
Drill: #29 [.136" (3.45mm) dia.]
8-32 UNC Tap
Drill: #7 [.201" (5.10mm) dia.]
1/4"-20 UNC Tap
3/8" [.375" (9.50mm) dia.]
through
4-1/4
(108)
6-3/4
(171.4)
• From centerline of pivot point to end
of track and hook-up box is 35-9/32
(896mm)
• Left hand door shown
• Do not scale drawing
• Dimensions are given in inches
(mm)
• Maximum door opening is 110°
2-3/8
(60.3)
Pinion Flat
Pinion Flat
RH Door
LH Door
2-5/8
(66.7)
4
(101.6)
4
(101.6)
1/4
(6.4)
4-3/4
(120.6)
5/16
(7.9)
1-1/8
(29)
4 Holes for Closer
4 Holes for Drop Plate
1/4-20 Machine Screw
or 3/8 Dia. Sex-Nuts
Ref. – Bottom of Frame Stop
1
(25)
3-1/8
(79)
12
(304.8)
Hinge or Pivot
19
(482.6)
2 Holes for Hook-Up Box:
8-32 Machine Screw
3 Holes for Track:
1/4-20 Machine Screw
8
(203.2)
11-1/4
(285.7)
12-1/16
(306.4)
34-3/16
(868.4)
For Concealed Wiring Only
1-1/8 (29) Hole for Conduit
Attaching Arm Stud to Slide
Retainer Clip
2
1
