2
15. Battery Compartment
16. Tamper Switch
17. Mounting Knockouts x 4
Features
B
B
a
a
t
t
t
t
e
e
r
r
y
y
The KP uses two
1.5V “AA” Lithium batteries
as its power source.
Power Saving Feature
- When idle, the Remote keypad will enter Power Saving Mode to save power.
- The LCD and keyboard back lights are turned off in Power Saving Mode.
- When the IR sensor detects a user approaching within 30-50 cm of the Remote Keypad, the
LCD light will turn on and displays the status of the system for 2 seconds. 4 types of status are
available:
I.
System Arm
The system is in armed mode
II.
System Disarm
The system is in disarmed mode
III.
System Home Arm
The system is in home armed mode
IV.
Alarm Memory
The system had an alarm that was not silenced.
- After the 2-second display, the Remote Keypad will prompt the user to enter PIN code.
- After 15 seconds of key inactivity, the power goes off and the Keypad returns to Power Saving
Mode.
Low Battery Voltage Detection
- The Keypad will detect battery status. If the battery voltage is low, a Low Battery signal will be
sent to the ZigBee network coordinator or system control panel.
Insert Battery
1 Remove the Keypad back cover.
2 Insert new batteries into battery compartment.
3 Remote Keypad will emit a short beep.
4 After 15 seconds of inactivity, the Remote Keypad will enter sleep mode.
5 Replace the back cover.
When changing batteries, after removing the old batteries, press the Tamper Switch twice to fully
discharge before inserting new battery
T
T
a
a
m
m
p
p
e
e
r
r
P
P
r
r
o
o
t
t
e
e
c
c
t
t
i
i
o
o
n
n
The Remote Keypad is protected against any attempt to open the back cover with a tamper
switch. When the back cover is opened, the tamper switch will be triggered and the Keypad will
transmit a tamper open signal to the ZigBee network coordinator or system control panel.
After replacing the back cover. The Keypad will transmit a tamper restore signal to the ZigBee
network coordinator or system control panel.
When the Keypad is properly mounted with back cover screwed onto the wall, removing the
keypad forcefully will break off the back cover from the hollowed section around the screw
location and activate tamper switch.
ZigBee Network Setup
Z
Z
i
i
g
g
B
B
e
e
e
e
D
D
e
e
v
v
i
i
c
c
e
e
G
G
u
u
i
i
d
d
e
e
l
l
i
i
n
n
e
e
ZigBee is a wireless communication protocol that is reliable, has low power consumption and has
high transmission efficiency. Based on the IEEE802.15.4 standard, ZigBee allows a large amount
of devices to be included in a network and coordinated for data exchange and signal transmission.
Due to the fundamental structure of ZigBee network, ZigBee device will actively seek and join
