8
Cycle the lock in both the locked and the unlocked positions. If problems are found:
HARDWARE TROUBLESHOOTING
8. Slide inside escutcheon over inside
support assembly.
CAUTION
:
a. Position motor cable against inside
support assembly. Avoid pinching wires
against the steel shank of the assembly.
b. “Z” fold touchscreen wire cable and lay
against the back recessed area of
the escutcheon assembly. Position and
bend wires to prevent binding when
installing the escutcheon over the
support assembly.
9. Install and secure the 10-32 x 3/4" pan
head screw through the center of the
battery housing into the barrel nut of
the outside assembly.
10. Slide on inside lever and push in to attach.
11. Insert four (4) AA alkaline batteries. The
lock responds, “
Welcome to the Yale
Digital World
.”
12. Install battery cover and tighten hex head
screw with Allen wrench provided with lock.
Directions, Continued
Symptom
Suggested Action
Door is binding
a. Check that door and frame are properly aligned and door is free swinging.
b. Check hinges: They should not be loose or have excessive wear on knuckles.
Latchbolt will not deadlock
a. Either strike is out of alignment or the gap between the door and jamb is too great.
Realign strike or shim strike out towards flat area of latchbolt.
Latchbolt does not retract or extend properly
Latchbolt tail and retractor are not properly positioned:
a. Remove lockset. Look though 2-1/8" hole and verify latchbolt tail is centered
between top and bottom of hole.
b. Remove latchbolt and insert lockset. Look though latchbolt hole and verify retractor
mouth centered in hole. If not, adjust outside rose plate.
c. If necessary, rebore holes to line up retractor and tail.
Test the Operation of the Mechanical Lockset
An ASSA ABLOY Group brand
80-9150-0075-010 (08-12)