10
Using the System
5
Changing your Key Pad PIN
The Pin code has been set during the app set up wizard.
You can modify the existing PIN code
using the app.You can set up to 10 sets of 4 digit
Go to app menu Settings > Alarm Settings > Key Pad PIN
code settings
Setting up Home Arm Mode
The Home Arm Mode allows the home to be partially
armed so that no one can get inside without first disarming
the system. However, the person inside the house can
move freely around without triggering the alarm. Home
mode is usually used to protect the ground floor when you
are upstairs in bed.
To enable Home Arm, you need to choose
the sensors
to be ignored
whilst in this mode. It would typically be the
bedroom PIR Motion Detector etc if you want to arm your
system during the night. These sensors should be set to
Home Omit in order to be ignored during Home Arm Mode.
If you wish to trigger an alarm count down with a sensor
during Home Arm Mode, allowing you time to disarm the
alarm when coming home, please select the mode: Home
Access.
Note! The PIR Motion Detector has a built in
battery save mode. After detecting motion,
they will wait for one minute without motion
before sending any signals to the Hub.
This saves battery power.
