Yale HSA6200, Installation, Programming, Operating

Page: 12 / 20

12
Setting or changing your keypad PIN
code
1 Press the Panic button A, enter “0000” (default
code). The LED will flash continuously to indicate
keypad test (programming) mode.
2 Press panic button B.
3 Enter new 4-digit PIN code.
4 Press Arm button to confirm.
5 Press disarm twice to quit the changing code
process. Or wait for 5 minutes for the keypad to
quit test mode automatically.
• If the code change is successful the LED will flash
twice. If there is an error the LED will flash 4 times.
• If the PIN code doesn’t change, repeat the above
procedure quickly without gaps.
• Write your code in the space provided below so
you don’t forget it
• If you wish to change the PIN code again, you will
need to enter your new changed PIN code instead
of “0000” as described in step 1.
• If there are 4 attempts to guess the code by
entering random 4 digit numbers, the keypad
will lock out for one minute after the fourth failed
attempt.
My PIN code
Arming the system
To arm the system press the “arm” button on the
keypad/keyfob. The siren will beep and flash
once. You can now leave your premises.
• A keypad will arm the system with a 20 second
exit period to leave the premises. Any detectors
activated during this time will be ignored by the
system. The system can be armed when inside
the protected area of your premises.
• A keyfob will arm the system instantly without
a 20 second exit delay. Any detector activated
afterwards will trigger an instant alarm. The
system should be armed when outside the
protected area of your premises.
• The system does not have an audible countdown
during the exit period.
• System tampers will be active during the exit
period.
Disarming the system
Keypad: Press disarm followed by your PIN code.
The siren will beep and flash twice.
• If the system has been armed with a keypad there
will be a 20 second entry period started when the
first detector is activated (usually a window/door
contact on the main point of entry). During this
entry period all detectors will be ignored.
• The siren will beep once when the first detector is
triggered.
• The system can be disarmed from inside the
protected area of your premises.
• If the system is not disarmed before the entry
period expires, the alarm will be activated.
• The system does not have an audible countdown
during the entry period.
• System tampers will be active during the entry
period.
Keyfob: Press “disarm”, the siren will beep and flash
twice.
• If the system has been armed with a keyfob there
will be no 20 second entry period and any detector
activation will give an instant alarm.
• The system should be disarmed from outside the
protected area of your premises.
Stopping the alarm
Keypad: Press disarm followed by your PIN code.
Keyfob: Press disarm.
The siren will be silenced and then beep and flash
twice.
Using the system
Arm and disarm the system and practice using it. Trigger the alarm by arming the system and
opening protected doors/windows and walking past PIRs. Now’s the time to set our pin code
and show the rest of the family how simple it is to use.
5