Further siren programming
The siren can be further programmed by the
use of jumpers if you desire.
Jumper positions
J7 on = jamming detection off;
off = jamming detection on
J6 on = normal, J6 off = clear memory
J5 on = stand alone operation;
off = slave operation, not used in this
system
J3 on, J4 on = 3 minute siren on period
J3 off, J4 on = 5 minute siren on period
J3 on, J4 off = 10 minute siren on period
J3 off, J4 off = 1 second siren on test period
J2 on = LEDs on during siren period;
off = LEDs on until system disarm
J1 on = normal; off = learn-in mode
• Jumper 5 must be left in the On position.
• J6 must be left on in normal service otherwise
the the siren will lose its learn-in memory when
the batteries are replaced.
• With J7 off, jamming by radio interference is
detected when continuously present for more
than 30 seconds and activates the siren only
when armed.
• If jumper 3 and jumper 4 are removed during
the learning-in process, the siren will sound for
1 second if accidentally activated and is useful
for testing. Ensure they are replaced before
replacing the covers.
9
Replace the battery and electronics
compartment covers, ensuring the gasket
between the electronics compartment and
cover is correctly located and the wires placed
in their slots to ensure a good seal from the
environment.
7
J1
J2
J3
J4
J5
J6
J7
Jamming detection
Clear memory (leave On)
Standalone mode (leave On)
Siren activation time
Siren activation time
Learning-in mode (leave On)
Strobe activation mode
Tamper alarm
If the siren detects a tamper condition it will
activate the siren for the programmed period. If
the tamper condition persists the siren will sound
a series of five pips either every time the system
is armed or when the tamper is enabled, to
indicate a fault.
Previous alarm warning
If there has been an alarm when you were
away the siren will sound and flash for 3 seconds
when being disarmed.
Warning
If the siren is activated for 3 seconds
when you disarm your system there could be an
intruder still in your premises.
Strobe led visibility
The strobe leds are intended to work together
with the siren to identify the alarm source.
The strobe is not designed to be viewed from
directly underneath or from the sides. It is
designed to be clearly visible from 10 to 50
metres in normal daylight conditions, away from
direct sunlight.
Intelligent Security & Fire Ltd
