YAKUMO PDA DELTA, Manual

Page: 98 / 113

90
7.2 Restoring Factory Default State
In some cases, you may need to restore your Pocket PC to the factory default
state by clearing the memory (RAM) from your Pocket PC. For example, you
should clear the memory:
When your Pocket PC does not respond after being reset.
When you forget your password.
Clearing the memory means all data you have entered in RAM, including all
files, system settings and additional programs you have installed, will be erased.
(Programs installed to ROM at the factory are not affected.)
CAUTION:
To ensure the integrity of your data should it be necessary to clear the memory, you’re
advised to regularly back up your data to your desktop computer (using ActiveSync) or
to a memory card (using the backup application). For more information on backing up
data, see section 3.5.
Do not slide the battery switch unless it is necessary.
Follow this procedure to clear the memory from your Pocket PC:
1. Backup your information if necessary.
2. Disconnect all cables, including the AC adapter, from your Pocket PC.
3. Stop all running programs by tapping
Settings System tab Memory icon Running
Programs
tab
Stop All
.
4. Use the stylus to slide the battery switch to the
OFF (up) position.
5. Wait for 1 minute and then slide the switch back
to the ON (down) position.
6. The red notification indicator on your Pocket PC
will flash for approximately 30 seconds. Then
your Pocket PC will automatically turn on and
display the Welcome screen.
7. To begin the Welcome Wizard, tap the screen
with the stylus and follow the onscreen
instructions to complete the Welcome Wizard.
Wait for 1 minute.