6100003631-Rev0.2
1/2
FIXED AND TRACK MOUNT KITS
®
LockNLoad Mk2 Leg Kit Instruction
THESE INSTRUCTIONS SUPPLEMENT
THE BAR/LEG INSTALLATION
SECTIONS THAT MAY STILL
FEATURE THE MK1 LEG IN YOUR
VEHICLE FIXED OR TRACK MOUNT
FITTING KIT INSTRUCTION
BAR INSTALLATION
INSERT LEGS
Slide the pre-assembled Leg assemblies into the
underside channel of LockNLoad Bars.
If Leg assemblies will not slide in,
loosen Screws to increase gap.
1
Note: Nut Plates
are not required.
LEVEL BARS - FIXED POINT
With vehicle on a level surface, adjust all
Bar angles to be level using a Spirit Level.
The Bar angle can be adjusted to reduce
any wind noise. In most cases this is
achieved by getting the Bar in-line
with air flow parallel to the ground.
2
Air Flow
SECURE LEGS TO BARS
Tighten all M8 Set
Screws to 9 Nm using
a 13 mm Spanner.
3
