OK
If crossbar will not slide in,
loosen tower hood bolt.
WARNING:
Avoid over loosening the bolt.
Dissassembly may occur!
Maneuver the crossbars
into the towers on the vehicle roof.
Tighten
hood bolts
after crossbars
are positioned.
WITH LEVERS
OPEN,
slide towers
onto bases.
Install SKS
®
Locks
following lock
instructions.
Rotate the small hole inside the
lock housing so that the point on
the core will align properly.
CLOSE levers on all
towers.
NOTE: Closing the levers
secures towers to bases.
If lever
WILL NOT CLOSE
COMPLETELY,
make sure
the base
is aligned
to the tower.
Install end caps
on crossbars.
TEST INSTALLATION
by pulling on each
tower and each bar.
Some play between
tower and base is
normal.
Check the included
RailRider Fit Sheet
for your vehicle’s limits.
DO NOT EXCEED
the maximum weight limit
of your factory tracks.
ALWAYS SECURE long
loads at the front and rear.
