28-13-335-Rev4
2/4
INSERT MOUNTING HARDWARE
x2
=
25mm
=
20mm
INSTALLATION
INSERT MOUNTING HARDWARE
Insert 2 x M6 Slot Nuts into the
channel where you want to mount
your shovel or similar tool.
1a
x2
NOTE -
LOCKN’LOAD Platform pictured
POSITION NUTS IN CHANNEL
Determine the best spacing for the Holders based
on the tool you will be carrying. For crossbars, it
is recommended to position Nuts close to the end
of crossbars and ensure they are equally spaced
as shown. The Allen Key can be used to assist Nut
movement within the channel.
INSTALLATION ONTO RECOVERY TRACKS OR
ACCESSORY MOUNTING BRACKETS
The Tee Nuts can be used to install the Ace’OSpades onto the Recovery
Tracks or Accessory Mounting Brackets as shown and following Steps 2 - 6.
=
16mm
=
25mm
=
16mm
x2
2X
Loosen then
slide the inboard
saddles all the
way down and
remove them.
#
2X
Install the
saddles into
the slot, raise
them up the
channel, and
tighten them
down.
1b
1c
1d
YAKIMA SHOWDOWN
1e
