![background image](http://html.mh-extra.com/html/yakima/8000355/8000355_quick-start-manual_893612004.webp)
28-13-356-Rev1.0
4/9
BAR PLACEMENT
Carefully place Bar assembly onto vehicle.
Take care not to damage vehicle.
Slide Legs
along Bar until
foot clamp sits snug against vehicle rail with pins positioned in rail holes.
Secure the Claw assembly to the vehicle rail using a 5 mm Allen Key or Torque Wrench.
Torque to 4 Nm.
Use a Tape Measure to ensure even Bar overhang on each side, re-adjust if required.
Repeat process for remaining Bar.
=
=
10
CHECK BAR SLOT MEASUREMENTS
Using a Tape Measure, record Leg to underside slot distance of
each Bar in the table (right). Ensure measurement is taken from
the centre of the Legs as shown. The ends of each bar should
be the same measurement respectively, if not, repeat Step 10.
BAR SLOT MEASUREMENTS
Front Bar (X)
Rear Bar (Y)
______mm x2
______mm x2
X
X = X
X
Y
Y = Y
Y
SECURE LEGS TO BARS
Given that the pivot assembly allows for degrees of freedom, check all plates are evenly
arranged and bars are in the desired position/angle before tightening M8 Hex Bolt to 7 Nm.
12
BAR SLOT COVERS
Cut Bar Slot Covers as per measurements recorded
in the table on Step 10 and push into underside
channel of front and rear Bar ends as shown.
NOTE
- Bar Slot Covers to be
inserted with fl at side visible.
13
11