35
If the portable node is already connected to a node or a room on the Internet
③
When connected to the same node or room as the ID of the previous connection history
The current connection ID is displayed in the LCD. To communicate with this
Communicating with other station
④
When connected to a node or room different from the previous connection history
The
“►” and the
current connection ID are displayed on the LCD.
When the DIAL knob is turned, the previous connection ID will blink. In this
case, press the
PTT
switch to connect to the previous connection ID.
While operating the Portable Node, it may not be possible to switch between “
Access Point
” and “
Direct Operation
”.
Press and hold the [
DX
] key to return to the transceiver setting screen, then press the [
A/B
] (DW) key.
While operating the portable node, the following functions may be set and operated on the portable node FTM-100D
transceiver.
Function
Key or Dial
Return to the transceiver setting screen
Press and hold the DX key
Adjusts the squelch level
Press the SQL (VOICE) key, then rotate the DIAL knob
Enters the BACKTRACK screen
Press the DISP (SETUP) key
Selects the Transmission Power Level
Press the TX PO key or press the P4 key on the microphone (By
default setting)
Selects Speaker Mute
Press the A/B (DW) key
Turning the display ON and OFF
Press and hold the DISP (SETUP) key
Disconnects a node or a room on the Internet
Press and hold the
*
key on the microphone
Setting the speaker mute
You can mute the audio output of the speaker of the node station FTM-100D transceiver.
You cannot set it in Direct Operation.
Touch the [
A/B
] (DW) key each time toggles the mute mode as follows.
MUTE OFF
MUTE ALL
MUTE TX
MUTE RX
MUTE OFF
・・・
MUTE OFF
: Disable mute.
MUTE ALL
: Mute both the received voice from the C4FM digital station and the voice from the node station on the
Internet.
MUTE RX
:
Mute the received voice from the C4FM digital station.
MUTE TX
:
Mute the voice from the node station on the Internet.
