SCU-17 USB I
nterfaCe
U
nIt
2
Virtual COM port driver Installation
Install the virtual COM port driver on the personal computer before using the
SCU-17 USB interface unit.
Please see the USB Driver (Virtual COM Port Driver) on the Yaesu Website for
details refer to (http://www.yaesu.com/) in the FTDX1200 product files section.
Note:
Do not connect the USB cable and SCU-17 to your personal computer
until after the “virtual COM port driver” installation is completed, because
an incorrect driver may be installed.
For assistance with the software port configuration, refer to “How to Confirm
the Installation, and the COM Port Number” in the “Virtual COM port Driver
Installation Manual”.
For information on port configuration for commercial and free computer soft
-
ware, refer to the manual for the software being used.
When using the USB cable to supply TX and RX audio signals, set the
Sound Card (input and output) settings to “USB Audio CODEC”.
When using the USB cable for computer TX control, the transceiver may
switch to transmit mode when the computer is started, etc.
YAESU does not provide technical support for the use or operation of com-
mercial or free computer software.
