Yaesu GS-232B, Manual, Page: 8 / 24

6
SDX Series Azimuth Rotator

Prepare the optional C-1000 Connection Cable.

Remove the Top Cover from the controller.

Connect the 8-pin connector of the C-1000 Connec-
tion cable to the exposed 8-pin connector located the
rear left corner in the controller.

Route the 5-pin connector of the C-1000 Connection
cable through out the rubber grommet on the rear pan-
el of the controller, and connect it to the AZ connector
on the rear panel of the GS-232B (Figure 4).

Replace the Top Cover.

Connect the supplied DC cable to a source of 12
VDC. The red lead connects to the Positive (+) DC
terminal, and the black lead connects to the Negative
(–) DC terminal. The GS-232B requires 70 mA. The
supplied cable has a 500-mA fast-blow fuse. Use only
the same type fuse for replacement.

Plug the coaxial power connector into the DC 12V
jack on the GS-232B rear panel.
p
ower
& c
ontrol
c
onnections
i
nst
alla
tion
To DC 12V Power Source To Serial port of the computer
SDX series
Azimuth Rotator
Figure 4
Output Grommet for
C-1000 Connection Cable
Exposed 8-pin Connector
(Inside of the Controller)
Optional C-1000 Connection Cable