62
S
c
a
n
n
in
g
Scanning
Searching for signals
The FTM-100DR/DE is equipped with a scanning function to search for memory
channels and frequencies with active signals.
Scanning can be performed using the following 5 methods:
VFO scan
Scan in VFO mode.
All Memory Channel Scan
Scan for all memory channels.
Select Memory Channel Scan
Scan for the specified memory channels.
Skip Memory Channel Scan
Skip the specified memory channels when scanning.
Programmable Memory Channel Scan (PMS)
Scan for the programmable memories.
VFO scan
1
Select the band to be scanned, and then switch to
VFO mode.
2
Press and hold
[UP]
or
[DWN]
on the microphone for
over one second.
Pressing
[UP]
scans in the higher frequency
direction.
Pressing
[DWN]
scans in the lower frequency
direction.
During scanning, the decimal point of the frequency
display blinks.
Once the transceiver receives a signal, the
transceiver continuously receives it until the signal
disappears, and restarts scanning 2 seconds after
the signal disappears.
Tips
• The scanning direction (UP/DOWN) can be set from
[5 SCAN]
[2 SCAN DIRECTION]
in the Setup menu. This scanning direction setting is applied for scanning performed by
pressing one of the
[P1]
to
[P4]
keys on the microphone to which
[SCAN]
is assigned in
advance from
[8 CONFIG]
[10 MIC PROGRAM KEY]
in Setup menu.
• The scanning direction can be changed by pressing and holding
[UP]
or
[DWN]
on the
microphone for over one second, or by rotating the DIAL while scanning.
• The operation performed after the scan stops on a signal, can be set from
[5 SCAN]
[3
SCAN RESUME]
in the Setup menu (refer to the next page).
• The squelch level can be adjusted even during scanning, by pressing
, and then
rotating DIAL.
