49
FT-90R O
PERATING
M
ANUAL
Miscellaneous Settings
While under most circumstances this should not occur (amplifier designs and
industry standards take this into account), if you find that your receiver squelch
does not open when both you and the other station are using a common DCS code,
you or the other station (
but not both
) can try the following:
1. Press and hold in the
key for one second, then rotate the
M
AIN
D
IAL
knob to select “
1 4 D C S n r
.”
2. Press the
key to select one of the following modes:
T R X N O R
:
Encoder
: Normal
Decoder
; Normal
RX REV
:
Encoder
: Normal
Decoder
; Reverse (Inverted)
TX REV
:
Encoder
: Reverse (Inverted)
Decoder
; Normal
TRX REV
:
Encoder
: Reverse (Inverted)
Decoder
; Reverse (Inverted)
3. Press and hold in the
key for 1.5 second to save the new setting and
exit to normal operation.
Remember to restore the default setting to “
T R X N O R
” (Encoder Normal; De-
coder Normal) when done.
Demonstration Mode
When the
FT-90R
is first turned on, the supplied DC voltage is displayed below
the field which shows the operating frequency. The
FT-90R
also provides an
alternative opening display option, called the “Demonstration” mode. This is a
two-line scrolling message which might, for example feature your callsign on the
top line and your name on the next line.
If your transceiver currently displays the DC voltage below the frequency, you can
activate the Demonstration mode by pressing and holding in the
button
while turning the transceiver on. The display will then indicate the demonstration
comments until you activate some function on the radio (rotate the
M
AIN
D
IAL
knob, etc.)
Press and hold in the
button return, while turning the
FT-90R
on, to
return to the normal opening display.
Summary of Contents for FT-90R
Page 35: ...33 FT 90R OPERATING MANUAL Note...
Page 61: ...59 FT 90R OPERATING MANUAL Notes...
