21
Receiver Accessories
Clarifier
(
Receiver Incremental Tuning
)
The Clarifier allows you to set an offset of up to ±9.99 kHz of the receive frequency relative
to your transmit frequency. To achieve a wider offset than this, you may use the “Split” op-
erating mode, described later.
1. Press the
switch momentarily to activate
the Clarifier function.
2. Turn the
knob, which allows the receiver
frequency to be varied over a range of 9.99
kHz.
3. When the receiving frequency is higher than
transmit frequency, the “ ” icon will appear at
the right of the frequency display. Similarly, when the receiving
frequency is lower than transmit frequency, the “ ” icon will
appear at the right of the frequency display.
4. When the receiving frequency is equal to transmit frequency
(Clarifier offset is zero) while the Clarifier is activated, the “
”
icon will appear at the right of the frequency display.
5.
To turn the Clarifier off, again press the
switch momentar-
ily. When you turn the Clarifier back on, the offset previously
stored will still be applied.
6.
To reset the Clarifier offset to zero, turn the Clarifier off, then
turn the
knob by any amount. The Clarifier will reset to
zero after the first “step” of the
knob.
If you leave the Clarifier on, moving the
knob will not
cause the offset to be cancelled.
CLAR
EL
S
A
B
C
F
V
LOCK
PWR
SQL/RF
AF
HOME
M
SEL
CLAR
[TX < RX]
[TX > RX]
[TX = RX]
