6
FT-818 Operating Manual
Installation
a
lkaline
b
atterY
i
nStallatiOn
and
u
Se
The
FT-818
is supplied with the
FBA-28
holder for Alkaline “AA” cells. A fresh set of
Alkaline cells should provide approximately 5.5 hours of reception under typical condi-
tions.
1. To install or replace the AA cells, first remove the battery cover from the bottom side
of the transceiver. Slide the battery cover latch forward, as shown in the illustration,
then fold the battery cover upward and set it aside temporarily.
2. Install the Alkaline AA cells as shown in the illustration, paying particular attention to
the correct polarity of the batteries.
3. When all batteries have been successfully installed, replace the battery cover.
Important Notes
When the transceiver is to be stored for a long period of time without use (longer
than ten days), remove the batteries from the
FBA-28
holder, to avoid the pos-
sibility of battery leaking causing damage to the transceiver. Inspect the
FBA-
28
battery holder occasionally for signs of corrosion or battery leakage, and
remove the batteries immediately if any such damage is observed.
The
FBA-28
battery holder is designed for use solely with Alkaline type “AA”
cells. Do not attempt to use Ni-Cd or other rechargeable cells in the
FBA-28
,
because it does not contain the protection circuitry required when using re-
chargeable cells.
When replacing batteries, replace all eight AA cells simultaneously with fresh
batteries.
When the battery voltage is approaching the value which indicates depletion is
near, the small “
” will blink, indicating it is time to replace the batteries.
