4. Press the [▲] or [▼] key to select one of the
modes described above.
5. Press the
PTT
switch to save the new setting and return to normal oper-
ation.
Disabling the Keypad and Scan Stop Beeper
An audible beep tone will sound when a keypad button is pressed, and also
when the receiver scanning stops. The beep tone operation may be changed
as shown in the below table:
Display
Description
KEY
The beeper sounds when a keypad button is
pressed.
KEY+SC(default setting)
The beeper sounds when a keypad button is
pressed, or when the receiver scanning stops.
OFF
The beeper does not sound.
1. Press and hold the
F
key to enter the Set Mode.
2. Press the [▲] or [▼] key to select Set Mode item “
5 BEEP
”
3. Press the
F
key to enable adjustment of this Item.
4. Press the [▲] or [▼] key to select “
OFF
”
5. Press the [▲] or [▼] key to select one of the
modes described above.
6. Press the
PTT
switch to save the new setting and return to normal oper-
ation.
7. To turn the beep back on again, select “
KEY
” or “
KEY+SC
(Default setting)”
in step 4 above.
25
Advanced Operation
FT-25R/FT-25E Operating Manual
Application for FCC / IC
FCC ID: K6620663X20, IC: 511B-20663X20
