Verifying the magnetic alarm connection?
When you have activated, the small LED-light on the accessorie should blink
rappidly when the connection is OK. If connection failed it will only turn the LED-
light on once for aprox 1-2 sec. If you do not get any response in the app, try again.
When activation is successfull you are ready to mount the magnet alarm. Please
wait approx 2 minutes before you connect another alarm accessory to the G32
system.
Mounting
Vibrations and chocks make the vibration sensor send an alarm. Note that after the
alarm is activated the sensor must be still for 10 seconds before it sends an alarm.
The vibration sensor can be mounted on metal materials with help of the magnetic
feet (Accessory). It’s also possible to mount it with the help of cable ties around
cables and other objects. The vibration sensor is waterproof and made for outdoor
environment. The signal from the sensor part to the alarm unit will pass through
walls and a big variety of materials. However, check the signal before mounting. Af-
ter the accessory has been connected to the alarm you are able to push the button
on the circuit card fast. If the LED light on the circuit board is flashing this means
that the distance range is enough. You will receive alarm directly in your phone if
the battery in the accessory has to be changed.
To change the level of sensitivity the sensor needs to be opened up. There is a
switch on the circuit card with three different positions (Low, medium, high) that
you can choose from.
Connection
button
Low:
Medium:
High:
1 2 3