Mounting
The main function of the remote control is to turn on and off the GPS-alarm. There
is also a SOS button that activates an alert message with position information
which is sent to the predefined alarm numbers. It’s also possible to put the alarm
unit in a low power consumption mode or control power of an external device, e.g.
a heater or fridge in a boat. The communication between the remote control and
the alarm unit is bidirectional. When the remote is flashing, it means that the com-
mand is sent and the alarm unit has received the key press. One or several remote
controls can be used for the same alarm unit.
Inactivate the alarm for theft and burglary.
Activate the alarm for theft and burglary.
Send a text message with the position of the alarm unit by holding the button down for
three seconds.
This button has two different functions.
• By pressing the button you can turn on or off the alarm unit’s output (this can be used to
control an external device, e.g. a heater or fridge). Valid only if the alarm unit ‘s output is
set as user control (off or on in App).
• To switch to the low power consumption mode hold down the button for about 10
seconds until the LED-light is flashing once. You also receive a text message with status
information to your predefined alarm numbers. To switch back you just hold down the
button again for about 10 seconds until the light is flashing.
Technical specifications
Measurements:
Battery lifetime:
Type of battery:
Battery capacity:
Distance range
(free sight):
Temperature range:
Sealing:
58 x 30 x 11 mm
up to 3 years
CR1632
130 mAh
approx 100 m
-30 to 70°C
IP54
Additions or adjustments to this manual can be found at
www.yachtsafe.se under the Manuals tab.