6
ERROR
NUMBER
CAUSE
DESCRIPTION
SOLUTION
SOLUTION
„Hot“ error code displayed
Err C01
Err C02
Err C08
Err C03
„ISP“ error code displayed
„Con“ and „Err“ error codes
displayed
„Err“ and „blank number“ error
codes displayed
Cutout switch enabled due to
overheating
Firmware error
Motor overcurrent
Pulse detection timed out
Power supply excess voltage
A collision has occurred
The system is experiencing a
connection error
Internal error
Wait until the components have
cooled down and the error code
„Hot“ has disappeared. The desk
is now ready to be used again.
Unplug the power supply from the
mains supply and wait 5 seconds.
Plug the power cable back into the
socket and try to move the desk
UP and DOWN.
Release all keys and wait for 5
seconds. Try to move the desk UP
and DOWN.
Reset the system to factory
settings
Release all buttons and wait until
the table has moved approx. 1 cm
against the current direction of
travel
Release all the keys and wait 5
seconds. Try moving the desk UP
and DOWN.
View the table down-below to find
the solution to the internal error
code displayed
4.4) ERROR MESSAGES ON THE HAND SWITCH DISPLAY
