Ya-man Waterpik WF-03, User Manual

Page: 9 / 34

9
E
N
G
LIS
H
It is recommended that this product be used after you brush your teeth. Guideline for use: 2 times/day
Filling the Reservoir
Open the reservoir cap and fill the reservoir with cold water or warm water.
Inserting and Removing Tips
Insert the tip into the insertion hole located on the top of the Water Flosser main unit. When the tip is locked correctly in the designated position,
the colored part at the center of the tip will be perfectly aligned with the top of the main unit. To remove the tip from the handle, press the tip
eject button and pull tip from handle.
Adjusting the Pressure Setting
Simply slide the power/water pressure adjustment switch to adjust the Water Flosser pressure setting.
Slide the power switch up and align it with (I) for low pressure. Align it with (II) for a high-pressure water jet. Use the product in accordance with
instructions from a dentist.
Recommended Technique
Lean low over sink and place the tip in mouth. Aim the tip toward teeth, and turn the unit ON (l).
For best results, start with the back teeth and work toward the front teeth. Glide tip along gumline and pause briefly between teeth. Continue
until you have cleaned the inside and outside of both the upper and lower teeth.
Direct the jet stream at a 90-degree angle to your gumline. Slightly close lips to avoid splashing but allow water to flow freely from mouth
into the sink. Keep unit upright during use for best results.
Caution
Do not press the tip forcefully against your teeth or gums.
High
Low
Off
Fill
Eject Insert