Version 1.0
PartPro120 xP Operation Manual
CONNECTING TO THE PRINTER
After plugging in the USB cable between the printer and the computer or completing the configuration of wireless
or Ethernet network on the printer, initial the connection with the following procedures:
1.
Click the printer monitor on the lower right corner.
2.
Wait while the software is scanning for the
available printers.
3.
All available printers will be listed at the bottom of [My Printer].
Cable connected printers will be listed under [USB] while other
machines connected through wireless or Ethernet network under
[Network].
Find the targeted printer with its serial number or IP address, and
click [Connect] to initial the connection.
If the target device does not appear here, click [Scan] button to retry
searching for the device.
4.
When the connection is set, [Connect]
button will change to [Connected]. You can
click to close the window and begin
other operation.
Layout Will Be Changed
Function Remain The Same
27
