Unpacking
Product Overview & Accessories
Nobel 1.0 is shipped with the following parts and accessories. After unpacking,
please inspect the interior and exterior of the printer and accessories for damage.
Please contact support for any missing or defective parts and accessories.
③
Select “UTILITIES” > “MOVE
PLATFORM”>“TO TOP”>“YES”
to raise the platform.
④
Remove the protective foam.
*Keep original packaging material in
the event of sending your unit back
for repair
Setting Up
Install and prepare the following parts before printing:
①
Install the resin tank by pushing
the tank all the way into its slot.
③
Shake the resin cartridge for about
10 seconds.
④
Assemble the nozzle cap and the
inner tube, and replace the bottle
cap with the assembled nozzle cap.
⑤
Install the filling tubes by first connecting
the black tube to the thick nozzle. Then attach
the transparent tube to the thin nozzle and
push the tube all the way down. After
installing the filling tubes, cover the lid.
②
Calibrate the platform by selecting
"UTILITIES" > " HORIZON CALIB" and
follow the instructions on the screen.
After removing prints from the
platform, loosen 4 small screws over
the platform. When the platform has
descended, press down on the
platform with your hands 3 times.
Then, after 5 seconds tighten the four
screws with your fingers. (sequence:
F1->F2->B1-B2). Finally tighten the
screws with a coin or other tools
(sequence: F1->B1->F2->B2).
Quick Start Guide
Welcome to your Nobel 1.0. Please read this guide carefully for tips on unpacking,
setting up, printing, and post processing to ensure an excellent 3D printing experi-
ence!
Platform
Filling Tubes
Cartridge Slot
Tank Slot
Operation Panel
Lid
Resin Tank
Rinse Basket
Gloves
Scraper
USB Flash Drive
Inner Tube
Nozzle cap
Power Cable
Power Adapter
Starter Resin
USB Wire
Power Jack
USB Wire Port
USB Drive Port
(Back View)
Power
Switch
Quick Start Guide
Warranty
Card
①
Upon receiving your printer,
remove the packaging materials,
plastic bag, orange tapes, and the
accessory tray from under the lid.
Then, remove the protective foam
from under the platform according
to the procedure below:
-1-
(US) XYZprinting, Inc. Email Support: [email protected] Website: http://us.xyzprinting.com
(EU) XYZprinting Netherlands B.V. Email Support: [email protected] Website http://eu.xyzprinting.com
ENGLISH
F1
F2
B1
B2
②
To remove the protective foam,
connect the printer to a power source
and turn on the printer. Initialization
will take approximately 10 min to
complete.
