P 22
V.1.3
da Vinci 1.0 Pro
Error Status
Recommended Process Ways
Printer is busy
Firmware of the printer
cannot be updated
Nozzle is clogged
Filament cannot be loaded
NO CARTRIDGE
Filament is not installed correctly
CARTRIDGE EMPTY
Filament ran out prior to a print : remain 0%
FILAMENT LOW
Filament residual is low: remain 30%
FILAMENT END
Filament ran out while printing : remain 0%
Try again after current task is completed, and examine the information
displayed on screen of the printer
Check internet connection / Update firmware later
Unload the filament to clean the nozzle, and then reload the filament
Unload and reload the filament
Reload or replace the filament
Replace filament immediately
Replace filament if necessary
Replace filament immediately
Support Details
Maintenance and Service
Federal Communications Commission (FCC) Statement
Keep original packaging material in the event of sending your unit back for repair during the warranty period.
If other packing materials are used instead, the print er may be damaged during the transportation process.. In
such situation, the XYZprinting the right to charge repair fee.
You are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the
user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and receiver.
● Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
● Consult the dealer or an experienced radio/TV technician for help.
XYZprinting is not responsible for any radio or television interference caused by using other than recommended cables and
connectors or by unauthorized changes or modifications to this equipment. Unauthorized changes or modifications could void
the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
This device complies with FCC radiation exposure limits set forth for an uncontrolled environment and it also complies with
Part 15 of the FCC RF Rules. This equipment must be installed and operated in accordance with provided instructions and the
antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must
not be co-located or operating in conjunction with any other antenna or transmitter. End-users and installers must be provided
with antenna installation instructions and consider removing the no-collocation statement.
