Xytronic LF-90, User Manual, Page: 7 / 10

11 12
VIII. Explosive View for Dismounting
A
Fault
Code
Fault Status Fault Cause Solutions
E06
1. Appear during start up
1. Lower sensor fails or poor
contact of lower sensor plug.
2. Upper mold motor fails
1. Open the rear cover, then, pull
out and insert
DOWN at the
adapter plate, and restart the
machine after confirmation.
2. Please contact the company.
2. While using, the upper
mold fails to drop to the
designated position.
3. The lower mold touches
the lower limit column.
E07
The warning indicator
lamp goes on, and the
lower mold extends out
along with continuous tick
sound
The safety door cannot be set at
the located position due to the
touch on safety door switch, the
safety door micro-switch fails or
there is a foreign matter
blockage. 1. Remove the foreign matter
which touches the safety door,
or move the safety door back
and forth to make it naturally
swing to the located position.
2. Please contact the company.
E19
All keys have no
response.
1.Main board fails.
2.The temperature of the heater
is above 250
℃
.
Please contact the company.
None
The film-sealing pattern
is uneven on left and right
sides.
Incorrect film photo sensor
position
Adjust the film photo sensor
position, for pattern deviation to
the left, please adjust the film
photo sensor upwards. For
pattern deviation to the right,
please adjust the film photo
sensor downwards.
None
After film-sealing
operation, the film is
melted to the cup mouth.
The temperature is too high.
It is suggested to adjust the
operating temperature
according to the film or properly
reduce the set temperature.
None
The sealing film is not
tight, water or air
leakage.
1. The film is incompatible with
the cup material. Adopt the film applicable to the
cup material.
2. The heater is adhered with
syrup or foreign matter.
Cut off the main power, and
scrub the heater with slightly wet
cloth after it is completely
cooled.
3. The cup-sealing time is too
short.
Increase P-3 film-sealing time.
4. The set temperature for cup-
sealing is too low. Increase P-1 film-sealing
temperature.
5.The cup may be deformed due
to improper storage
Replace the normal cup
6.The paper cups film is too
thin to sealing
Replace the normal cup
None Draggy film cutting
The film cutter is not sharp
enough, or the film cutter is
adhered with foreign matter. Continuously execute the cutter
soaking program, and then
remove the foreign matter.
None
The film cannot be
completely cut off.
Film chip or foreign matter exists
between the film cutter and the
heater. Cut off the main power, and
remove the foreign matter after
it is completely cooled.
No. Name Quantity No. Name Quantity
A1 Nut 2 A2 spring-washer 2
A3 Film support rod 2 A4 Screw 2
A5 Spring-washer 2 A6 Film support rod bracket 1
A7 Screw 4 A8 Film cutter 1
A9 Screw 4 A10 Flat-washer 4
A11 Spring 4 A12 Film-pressing cup 1
A13 Screw 4 A14 Film-sealing spring 4
A15 Heater 1 A16 Screw 1
A17 Temperature sensor 1 A18 Screw 3
A19 Support plate 1 A20 Film cutter holder 1
A21 Sealing cap 1