Handle:
Advances items
through the machine
when turned clockwise.
The Built-in Grip/Carry Handle:
Take your machine almost
anywhere.
The Input Tray:
Use to feed items into tray.
Patented Easy Loading Cartridge:
Allows you to replace
cartrige in seconds.
Removable Trimmer:
Makes it easy to cut.
Place item on feed tray.
Guide item forward while slowly
turning knob clockwise until your
item comes out of the back of
the machine.
Open cartridge compartment
by lifting up on latch.
Gently pull cartridge up
and out of machine.
Open lid. Slide cartridge down
into tracks on machine sides with
exposed roll of material facing
open lid cover. Close lid securely.
Advance laminate and trim.
Cut Blade
To Replace the Cut Blade
Basic Operation as easy as 1-2-3!
• For best results, turn the handle slowly.
• If machine rollers pick up adhesive after
use, clean with isopropanol alcohol.
• Store your machine and cartridge between
40ºF and 70ºF
Helpful Hints
Features & Functions
Press down on cut blade and
slide to the left or right to cut.
Note: For a smooth cut, place
your finger all the way back to
the back of the cut blade holder.
Unloading & Loading
1 Insert Item
2 Turn Handle
3 Trim
1 Insert Item
1
Loosen and remove the screw in the
cut bar with wrench. Remove colored
plastic insert and slide the old blade
off cut bar (safely discard old blade).
Visit
www.xyron.com
for more information.
2
Carefully slide new blade onto cut bar.
Note: Sharp edge of blade should be
facing the machine. Replace the colored
plastic insert and secure with wrench.
3 Trim
• Can laminate up to 8
7
/
8
” wide and up to 60’ long.
• Xyron laminates are adhesive based, so they will
not peel or separate. You can cut close to edge
or into document itself.
2 Turn Handle
