DIQ/S 281
Settings/setup
75
ba77244d01
08/2020
5.6
Alarm settings
5.6.1 General information
Under this menu item you can specify reactions on certain alarm events.
An alarm event is when a certain measured value (limiting value) of a sensor is
exceeded or undercut.
Alarm events can be relayed as follows:
As a message on the display
As a relay action
5.6.2 Setting up / editing alarms
figure 5-6
Edit list of outputs -> enter a name
An alarm message via display or relay cannot be acknowledged or
switched off. An alarm only disappears if the cause for the alarm
was eliminated or the
Alarm settings
were changed or erased.
1
Open the
Einstellungen/Settings
menu with
<S>
.
2
Using
<
>
and
<OK>
, select and confirm the menu item,
Alarm
settings
.
The
Alarm link overview
dialog window opens.
Alarms that have already been set up have entries in the
Sensor
column.
