en – Original instructions
7
•
Allow all pump system components to cool before handling them
•
Make sure that the product has been thoroughly cleaned
•
Disconnect and lock out power before you service the pump
•
Check the explosion risk before you weld or use electric hand tools.
Precautions during work
WARNING:
•
Never work alone
•
Always wear personal protective equipment
•
Always use suitable working tools
•
Always lift the product by its lifting device
•
Stay clear of suspended loads
•
Beware of the risk of a sudden start if the product is used with an automatic level control
•
Beware of the starting jerk, which can be powerful
•
Rinse the components in water after you disassemble the pump
•
Do not exceed the maximum working pressure of the pump
•
Do not open any vent or drain valve or remove any plugs while the system is pressurized
•
Make sure that the pump is isolated from the system and that all pressure is released before
disassembling the pump, removing plugs, or disconnecting the piping
•
Never operate the pump without a properly installed coupling guard.
In case of contact with chemical substances or dangerous liquids
Follow these procedures for chemicals or hazardous fluids that have come into contact with your
eyes or your skin:
Condition
Action
Chemicals or hazardous fluids in
eyes
1.
Hold your eyelids apart forcibly with your fingers.
2.
Rinse the eyes with eyewash or running water for at least 15 min.
3.
Seek medical attention.
Chemicals or hazardous fluids on
skin
1.
Remove contaminated clothing.
2.
Wash the skin with soap and water for at least 1 min.
3.
Seek medical attention, if necessary.
1.2.4 Protection of the environment
Disposal of packaging and product
Comply with the current regulations on sorted waste disposal.
1.2.5 Sites exposed to ionizing radiations
WARNING: Ionizing radiation hazard
If the product has been exposed to ionizing radiations, implement the necessary safety measures
for the protection of people. If the product needs to be despatched, inform the carrier and the
recipient accordingly, so that appropriate safety measures can be put in place.
1.3 Spare parts
Identify the spare parts with the product codes directly on the site www.lowara.com/spark.
Contact Xylem or the Authorised Distributor for technical information.
1.4 Product warranty
For information on the warranty refer to the documentation of the sale contract.
