Xylem JABSCO 62040-4 Series, Instruction Manual

Page: 4 / 24

4
Key
No.
Part Description
62040-Series 62042-Series
Part No. Qty. Part No. Qty.
1 Base (includes set screw) − − − −
2
Housing (rubber boot installed)
(includes end bell (No.8) on 7” & 8”)
Chrome - Brass Housing
43998-0000 1 − −
3
Screws for mounting housing
(package of 4 screws)
66138-0000 1 66138-0000 1
4 Rubber Boot (includes straps and fasteners) 43990-0046 1 43990-0046 1
5 Motor Clutch Assembly (assembled and wired) 43990-0076 1 43990-0076 1
6
Motor & Pinion Kit (vertical
horizontal)* 43990-0078
43990-0078 1
1 43990-0078
43990-0078 1
1
7 Bulb Retaining Ring (chrome) (w/fasteners) 43990-0039 1 43990-0040 1
8 End Bell (w/fasteners) See Key #2 − See Key #2 −
9 Gasket (base mount) 66157-0000 1 66157-0000 1
10
Bulb 12 Vdc
24 Vdc 67262-0000
18753-0447 1
1 −
98040-0520
−
1
Gear & Clutch Kit (not shown)
Replacement 8-Way Switch
for Control (not shown) 43990-0069
43990-0000 1
1 43990-0069
43990-0000 1
1
*Vertical & horizontal refer to movement, not orientation or the motor inside the housing.
Reference image on page 3
BULB REPLACEMENT
Loosen screw and remove bulb retaining ring.
Disconnect wires from faulty bulb. Connect wires to new bulb as
shown. Install bulb and fasten with bulb retaining ring.
SINGLE FILAMENT
Black
(Neg.)
Gray &
Orange
(Spot)
WIRING
DIAGRAM
SINGLE CONTROL
7” & 8” MODELS
POWER INPUT LEADS SUPPLIED
BY CUSTOMER (16 GA.)
CONTROL
CONTROLLED CABLE MUST BE
ACQUIRED SEPARATELY
(SEE CABLE LISTING)