Xylem FLYGT MAS 711, Installation, Operation And Maintenance Manual

Page: 33 / 72

6. Click Setup > General configuration > Ethernet.
7. Enter Ethernet settings
a) Set the Gateway to 0.0.0.0.
b) Click Update.
6.8.12 Set up a MAS network overview
A MAS network overview shows key data and alarm status from other units that are
connected to the same network.
1. Click Setup > MAS network overview.
WS009573A
2. Select Active in the Activate network data sharing drop-down menu.
3. Enter the expected number of units on the network.
This number allows this unit to detect when other units in the network are turned off or
do not work correctly.
To share and receive information through the MAS network overview, the units must
be connected on the same side of any router on the network.
4. Enter the assigned HTTP port in the router.
When there is direct LAN and not Internet connection, this text box can remain blank.
A router with port forwarding is needed when access to the MAS network comes from
the Internet. With port forwarding, it is possible to follow a link from one unit to
another.
5. Enter the Data transfer interval and the MAS network overview reload time.
6. Click Update.
6.8.13 Set up a MAS relay module
1. Make sure that the communication with the relay modules is turned on.
2. Click Setup > General configuration > Relay Modules, MRM 01.
6 System Setup
MAS 711 Installation, Operation, and Maintenance Manual 31