TLC 750 BT / TLC 750 NFC
Operation Manual
Page 13
12. Standards
This product meets the requirements of the standard DIN EN 13485
Suitability: S, T (storage, transport)
Environment: E
Accuracy class: 0.5
According to DIN EN 13485 is a regular check and calibration of the meter necessary.
13. Regulatory information
General
This device is tested according to ETSI EN.
It meets the requirements of ETSI EN
Radio approvals
RED
EN 61000-4-2
EN 61000-4-3
EN 61326-1:2006
EN 62368-1:2014
EN 62311
ETSI EN 300 330
ETSI EN 303 ETSI EN 300 328 V 2.1.1
ETSI EN 301 489-1 V 2.1.1
EN 301 489-3
EN 301 489-17
FCC
FCC ID: VQ5-TLC750NFC
This device contains FCC ID: QOQBGM113
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
The Federal Communications Commission (FCC) warns the users that
changes or modifications to the unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
FCC §15.105 (b):
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reason-able protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be deter-mined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit different from
