1.
Connect the video output to the monitor or other video device
through a 75 Ohms type coaxial cable.
2.
Connect the power source, insert the AC plug into the AC socket and
the DC plug into the DC Jack (+12V DC in jack centre).
3.
Once the picture appears on the monitor, open the cover and make
the Zoom Adjustment by rotating the screw (NEAR-Anti-clockwise,
FAR-Clockwise) until you get the desired view. Next make the Focal
Adjustment by rotating the screw (TELE-Anti-clockwise, WIDE-
Clockwise) until you get the desired view.
4.
Tighten the two screws, then replace the dome cover.
Figure 4
How to Operate
To DC Power
Source
To Monitor
STEP 4: The vertical angle can be adjusted by loosening the 2 screws (as
shown in Figure 2) and by turning the camera housing vertically.
STEP 5: The horizontal angle can be adjusted by loosening the nut on the
back and by turning the camera housing horizontally (as shown
in Figure 3).
STEP 6: Place the dome cover on the camera and tighten it by turning it
clockwise.
Figure 3
Figure 2
