Xvent s.r.o.
Poděbradská 289
53009 Pardubice-Trnová
Verze 001-GBR (25.8.2022)
Page
4
z
6
D-502-0283
- Xhouse unit connection to the power
- Connection of the unit in to the electric box
-
Input wire is ready from the manufacturer for connection in to the
electric box.
- For connection of the income wire to the electric power network use
appropriate components. (IE connectors, spring clamps)
- Connection of the unit to the electric socket
-
Income wire is possible to connect with plug with security connector
(pin) – this is not part of the delivery.
Installation of the income wire to the electric box or installation of the plug to the income wire and connection to the electric
power network has to be performed only by authorised person and inline with safety law instructions valid in the area of the
installation.
.
5) Controls – electro accessories to the Xflat
-
For the correct operation of the unit (in manual mode), there is no need to connect anything else. It is ready for immediate use after installation
on the wall. For operation in automatic mode, you must connect the air quality sensor accessories CO2 (NL-ECO-CO2) or RH (NL-ECO-RH).
-
Connection of electrical accessories
-
Before connecting electrical accessories, always switch off the unit at the remote control and the main switch.
- Connect the electrical accessories in the control box. To connect accessories, use the membrane multi-through. To access the control
box, proceed as follows:
- Connection of CO2 (NL-ECO-CO2) and RH (NL-ECO-
RH) sensors - AQS sensors (AQS CO2
- Spring clamps with manual wire locking
are used to connect the individual
components. Both a licna-type conductor
(cable with a sleeve) and a solid conductor
(wire) can be installed in the terminals
with a cross-section ranging from 0.5 to
1.5 mm², exposed length 10 mm. Before
inserting the wire into the terminals, first
press the locking orange button. Then
insert the wire, release the lock and check
that the wire is properly secured by pulling
slightly on the clamp. If you need to
remove the wire from the terminal, the
procedure is the same. Choose the
optimal conductor cross-section according
to the length of the conductor route.
a)
loosen the grommet nuts
e)
Connect the cable to the appropriate terminals in the motherboard according to the
- K It is possible to connect 2x AQS sensors (1xCO2 and 1xRH) to
the unit, which are used to measure the content of CO2
concentration and humidity – RH in the air at the place where the
sensors are installed. Thanks to the sensors, it is possible to
operate the unit in automatic mode, which automatically controls
the operation and air output of the unit according to the current
need in the given space where the sensors are installed. At the
same time, this method of management is the most efficient in
terms of economy of operation – it only ventilates as needed. If
necessary, it is possible to connect up to 8 sensors of one type to
the unit using the "PRO-SUM-08" accessory.
Sensor AQS
RH
Sensor AQS
CO
2
b)
unscrew the securing screws of the
regulation cover - remove the cover
c)
pass the cable through the membrane
Terminal
bridge for
switching NC
and NO
switching logic
GREEN-YELLOW (PE) –
SECURITY WIRE
BLUE (N) – NEUTRAL WIRE
BLACK/BROWN (L) – PHASE
WIRE
