10
SOUND SETTINGS
ROOM TUNING - MECHANICAL
ADJUSTMENT OF THE
BOUNDARY FREQUENCY
By using the supplied bass plug in the bass reflex port, you can alter the lower
boundary frequency on the Master M2
Closed port
With the full bass plug mounted in the bass reflex port, the cabinet is closed and
the loudspeaker operates as a closed construction. This yields a more ”tight”
bass reproduction and smoother roll off.
Bass reflex, low
With the low resonance bass plug mounted in the bass reflex port, the cabinet is
a bass reflex construction. The low frequency resonance is at it its lowest point
with a flat bass reproduction.
Bass reflex
With no plug present in the port you have a higher bass level and more alert
bass reproduction. The bass is not as deep as the bass reflex, low mode.
These settings also depend
on the size and shape of
the room, and also on your
own taste, so please have
patience when trying out your
preferred setting.
BINDING POST / BI-WIRING
1. Upper terminal + lower terminal (loops present) - Default setting, the
loudspeaker is fed with the entire frequency range. In this mode, it doesn’t
matter which connectors you use when connecting the speaker cables.
Without the loop between upper and lower terminal:
2. Upper terminal. The signal is only fed to the tweeter.
3. Lower terminal. Now the signal is fed to the woofer only.
PLEASE NOTE!! When the loops
are connected, ensure that
all four contacts are properly
fastened so that the loops
connectors are stuck -if the
loop falls of, it may short-
circuit between the + and -
contact and thus damage the
amplifier.
Summary of Contents for Master M2
Page 1: ...Master M2 Owners Manual ...
