6. Install the original silicone keys onto the new plastic housing as shown in picture 1.3
Install the original silicone keys and components onto the new plastic shell 1.3
7. After installing all silicone keys, buttons, car disc flannel and car disc mirror onto the
new plastic shell, place the original PCB board as shown in picture 1.4
8. Install the original trimmed plastic shell onto the new plastic shell. Please note that
3 of the screws cannot be locked at the back cover circled as shown in picture 1.5
9. Open the original cigarette lighter cover and use the tweezers to open the cigarette
lighter in the two vinyl points, remove the cigarette lighter hardware inner shell.
10. Remove the plastic cigarette lighter cover and install it onto the new plastic shell,
also install the cigarette lighter hardware inner shell.
11. Connect all necessary cables.
Original PCB board installed onto
the new plastic shell
Install the PCB kits to the new
plastic shell
Caution: These 3 screws cannot be locked.
1.3
15
1.4
1.5
