SAFETY INFORMATION
1
Read all safety warnings and instructions. Failure to follow the warnings and instructions may result in
injury and/or property damage. Save all warnings and instructions for future reference.
The warnings, precautions, and instructions discussed in this instruction manual cannot cover all
possible conditions and situations that may occur. It must be understood by the operator that common
sense and caution are factors which cannot be built into this product, but must be supplied by the
operator.
BEFORE USING YOUR PUMP
• In all cases, motors are designed for operating vo or - 10% of the normal rating. Singles voltage motors
are supplied fully connected and ready to operate.
• C
onfirm the votage and frequency at the outlet match the specifications on the pump motor decal.
•
Check the On/Off switch to be sure it is in the OFF position before plugging it into the outlet
.
• The pump is shipped without oil in the reservoir. Before starting the pump, fill it with oil.
.
WARNING
Risk of improper wiring, piping, moving, lifting and handling can cause injury and equipment damage. Installation
and service of this equipment should be done only by a qualified technician.
•
CAUTION
: Risk of contact with sharp edges and exposed fasteners can cause injury. Only properly trained
and qualified personnel wearing appropriate OSHA - approved PPE should attampt to move, lift or remove
packaging from or prepare the unit for installation.
•
CAUTION
: Risk of contact with hot surfaces, The refrigerant discharge lines, motor and some electrical
components are extremely hot during operation Allow sufficient time for the unit to cool down.
•
CAUTION
: Risk of electric shock and short circuits. These can casue injury and/or equipment damage.
• Wear safety goggles when working with refrigerants. Contact with refrigerants may cause eye injury.
• Incorrect use or electrical connections may cause electrical shock. Read and follow instructions carefully, and
take precautions to avoid electrical shock hazards. All associated devices must be correctly grounded before
energizing circuits.
Normal operating temperatures will cause certain external portions of the pump to be hot to the touch. Do not
touch the pump housing or motor during operation.
SAVE THESE WARNINGS.
Summary of Contents for 71094
Page 3: ...PARTS INFORMATION 2 ...
Page 4: ...PARTS INFORMATION 3 TECHNICAL PARAMETERS ...
Page 7: ...6 TROUBLESHOOTING ...
