XtremeAIR XA41, Maintenance Manual

Page: 215 / 284

Maintenance Manual XA41/XA42
AMM-XA42-0040-001 C.00
Page date: Page 7
25.09.2018 Chapter 55
55-60-00 RUDDER
To remove the rudder:
1 Cut the safety wires. Remove the bolts of the lower connection of the rudder (AN5H-
6A bolts, ½” wrench) (refer to Figure 55-7).
2 Remove the rudder hinge pin (5mm Allen key).
3 Pull the rudder out to the top.
4 Remove the rudder.
To install the rudder:
1 Lift the rudder into position.
2 Push the rudder hinge pin in from the top.
3 Torque the hinge pin (5mm Allen key) to 15Nm (11lbs/ft). Safety the connection
with Loctite 243.
4 Seal the connection with locking varnish.
5 Install the AN5H-6A bolts (½” wrench). Torque the bolts.
6 Safety the bolts with new 0.032”safety wire.
7 Do these checks:
 The rudder must move freely from stop to stop.

Deflection, tolerance and permitted play must agree with the table of chapter 27-00-
00.
No. Quantity Component P/N
1 1 Rudder XA42-5560-100
2 1 Rudder hinge pin XA42-5560-180
3 2 Hexagon head bolt AN5H-6A
4 - Safety wire MS20995C32
Figure 55-7: Installation rudder