XtremeAIR XA41, Maintenance Manual

Page: 167 / 284

Maintenance Manual XA41/XA42
AMM-XA42-0040-001 C.00
Page date: Page 21
25.09.2018 Chapter 32
32-50-00 MAIN LANDING GEAR FAIRINGS
The main landing gear fairings consist of four parts each leg: The upper strut fairing, the leg
fairing, the wheel pants and the brake cover.
For installation details on the complete landing gear fairings, refer to Figure 32-12.
To remove the wheel pants:
1
Remove the screws from the brake cover on the respective wheel pant (Pos. 9).
Remove the brake cover (Pos. 7 and 8).
2 Remove the screws from the inner front side of each wheel pant (Pos. 11). Remove
the outer screw from the axle standoff stub (Pos. 13). Remove the wheel pant.
3 Assemble the wheel pants in the opposite sequence. Make sure that there is a
sufficient clearance between the wheel pant and the tyre.
To remove the upper strut fairing and the leg fairing:
1 Remove the cowling. Refer to chapter 71-10-00.
2 Shore the front of the aircraft. Refer to chapter 07-20-01.
3 Remove the landing gear. Refer to chapter 32-10-00.
4 Remove both leg fairing parts together, or separate them by removing the screw
that connects them (Pos. 9).
5 Assemble the leg fairings in the opposite sequence.
No. Quantity Component P/N Note
1 1 Wheel Pant LH XA42-3250-151
2 1 Wheel Pant RH XA42-3250-156
3 1 Upper strut fairing LH XA42-3250-211
4 1 Upper strut fairing RH XA42-3250-212
5 1 Leg fairing LH XA42-3250-215
6 1 Leg fearing RH XA42-3250-216
7
1 Brake Cover LH XA42-3250-221 Grove
1 Brake cover Beringer LH XA42-3250-223 Beringer
8
1 Brake Cover RH XA42-3250-222 Grove
1 Brake cover Beringer RH XA42-3250-224 Beringer
9 12 Screw AN526-10R8
10 2 Washer DIN 9021 6,4 (M6)
11 4 Screw AN526-10R10
12 2 Screw AN526-10R12
13
2 Screw AN4H3A Grove
2 Screw DIN 933 M6x55 Beringer
14 12 Nut plate XS-0210-101
15
2 Tooth disc MS35333-40 Grove
2 Tooth disc DIN 6797 Form F 6,4 (M6) Beringer
16 2 Spacer Beringer XA42-3210-223 Beringer