XtremeAIR XA41, Maintenance Manual

Page: 163 / 284

Maintenance Manual XA41/XA42
AMM-XA42-0040-001 C.00
Page date: Page 17
25.09.2018 Chapter 32
Tail wheel:
To disassemble the tail wheel:
1 Remove the tail wheel axle. Refer to Figure 32-3, detail Z.
2 Disassemble the tail wheel. Refer to Figure 32-3, detail Z.
3 Assemble the tail wheel in the opposite sequence.
4 Make sure that the wheel turns freely.
32-40-02 Brakes
Beringer HE2 brakes:
Refer to the manufacturer’s maintenance and overhaul manual BRG-ALTP-02 MM-ETSO-007.
Grove brakes:
Inspection:
1
Visually examine the caliper for corrosion, leakage of hydraulic fluid, cracks or other
damage.
2 Examine the attachment bolts of the back plate to make sure that they are correctly
torqued and safetied with wire.
3 Visually examine the torque plate for corrosion, cracks and loose bolts that attach
the torque plate to the axle.
4 Make sure that there is no brake fluid on the brake linings. Replace the brake linings
if there is brake fluid.
5 Examine the brake linings and the brake line fittings for signs of damage or leakage.
Replace the linings that are worn to less than 0.100” (2,5mm) thickness.
Removal and inspection of brake linings:
1 Remove the safety wire and the attaching bolts from the back plate. Remove the
back plate assembly.
2 Move the brake caliper out of the torque plate assembly. If it is necessary to remove
the brake line, put caps or plugs on the hydraulic lines to prevent contamination.
After installation of the brake caliper, bleed the brakes, refer to chapter 12-10-06.
3 Move the press plate assembly out of the torque pins.
4 To remove used brake linings, remove the rivets with an applicable tool (such as
Rapco Brake Rivet tool kit RA825).