Xtreme Power 96958, Owner'S Manual And Safety Instructions

Page: 8 / 16

ASSEMBLY
7
96958 Tools Required:
Medium Phillips Screwdriver
HANDLE ASSEMBLY:
1.
Align the holes in the upper housing with the 2 holes in the
handle as shown. Insert and tighten screws securely with the
screwdriver.
1.
Insert tabs on the cord wrap into slots in the shell support, lining up the holes on the cord wrap with those
on the side cover. Insert and tighten screws securely with the screwdriver.
CORD WRAP ASSEMBLY:
96959 Tools Required: Medium Phillips Screwdriver, 5/16” open end or adjustable wrench, needle nose
pliers.
FRAME AND WHEELS ASSEMBLY:
1. Slide the axle through in the wheel
support frame.
2. Slide wheels onto each axle, make
sure the valve stern (if pneumatic) is to
the outside.
3. Slide flat washers (L) onto the axle
past the small hole. Insert a cotter pin
in the axle hole and bent legs of the pin
with needle nose pliers and secure.
4. Place heater on the assembled frame,
make sure that the air inlet end is by the
wheels and the mounting holes on the
tank flange of the heater align with holes
in the frame.
5.
Take the rear handle and align the
mounting holes with the corresponding
holes in the tank flange/wheel flange,
Slide a screw through the holes and
loosely attach a nut. Repeat for the other
2 holes, then fully tighten all 6 screws
and nuts.