Xtreme Power 82104, Owner'S Manual And Safety Instructions

Page: 8 / 16

7
CHAIN OIL :
The chain oil flow can be changed by inserting a screwdriver in the hole on the bottom of
the clutch side. Adjust according to your work conditions. (F13)
NOTE :
the oil tank should become nearly empty by the time fuel is used up. Be sure to refill the oil tank
every time when refuelling the unit.
ADJUSTING THE CARBURETTOR :
The carburettor on your unit has been factory adjusted but may
require fine tuning due to changes in operating conditions. Before adjusting carburettor, make sure the to
provide air and fuel filters that are clean and the fuel is properly mixed. Be sure to adjust the carburettor
with the bar chain attached. When adjusting, take the following steps:
1.
Stop the engine and screw in both H and L needles until they stop. Never
force them. Then set them back the initial number of turns as shown below.
H Needle: 1 3/8
L Needle 1 ¼
2.
Start the engine and allow it to warm up at half-throttle.
3. Turn the L Needle slowly clockwise to find a position where idling speed is
maximum, then set the needle back a quarter (1/4) turn counter-clockwise.
4.
Turn the idle adjusting screw (T) counter-clockwise so that the chainsaw does not turn. If idling speed
is too slow, turn the screw clockwise.
5.
Make a test cut and adjust the H Needle for best cutting power, not for maximum speed.
(1) L Needle
(2) H Needle
(3) Idle Adjusting Screw
CHAIN BRAKE
: This machine is equipped with an automatic brake to stop chainsaw rotation upon
occurrence of kickback while in saw cutting operation. The brake is automatically operated by inertial
force which acts on the weight fitted inside the front guard. This brake can also be operated manually with
the front guard turned down to the guide bar. (F15). To release the brake, pull up the front guard toward
the front handle until you hear it click.
HOW TO CONFIRM BRAKE OPERATION:
1.
Turn off the engine
2.
Holding the chainsaw horizontally, release your hand from the front handle, hit the tip of the guide bar to
a stump or a piece of wood and confirm brake operation. Operating level varies by bar size. (F16) In case
the brake is not effective, ask our dealer inspection and repairing the engine.
3.
If being kept rotating at high speed with the brake engaged, can heat the clutch and cause a lot of
problems. When the brake is depressed while in operation, immediately release your fingers from the
throttle lever and keep the engine idling.
GUIDELINES