Xtreme Power 81094, Owner'S Manual And Safety Instructions

Page: 8 / 12

3. Auger Drill (33a) Maintenance: Using the Auger while that is bent or filled with excessive debris can cause
serious injury. Be sure to replace a defective Auger and always keep the unit clean.
4. Spark Pug (51) Maintenance: The condition of the Spark Plug should be checked ever six months or
every 100 hours of total use. If necessary, clean or replace the Spark Plug. The recommended Spark Plug
replacement type is: L7T
5. Air Filter (78) Maintenance: The Air Filter should be checked prior to each use of the Auger Drill for debris
and buildup. The Air Filter should be replaced every 3 months or 50 hours of tool use.
6. Gearbox (8a) Maintenance: The Gearbox should be checked prior to each use for proper quantity. If
necessary, fill the Gearbox with SAE 80-90 weight gear oil. The Gearbox should be filled with clean Gear oil
every 3 months or after 50 hours of tool use.
7. To Clean the Auger Drill: Use a clean cloth and mild detergent to clean the exterior of the engine. DO NOT
use Solvents. Rinse off with caution, DO NOT introduce liquids into the interior of the engine.
CAUTION:
All maintenance, service or repairs not mentioned in this manual must only be performed by a
qualified service technician.
Many maintenance procedures, including any not detailed in this manual, will need
to be performed by a qualified technician for safety. If you have any doubts about
your ability to safely service the Auger or engine, have a qualified technician service
the Auger instead.
1. Insert the shank of the Bit fully upward into the Transmission Socket on the
bottom of the Auger. Secure the Bit in the Transmission Socket, using the Pin and
R-Pin.
2. Place the Auger on its side with its Bit resting on the ground that is to be drilled.
Press the Primer three or four times.
3. Set the Choke, START if the Engine is cold. RUN if the Engine is warm.
4. Move the Power Switch to the I position. Squeeze and release the Throttle.
5. Grip the Frame firmly with your left hand. Keep all body parts well away from
the Bit. Then, with your right hand, grip the Starter Handle of the Engine gently
until resistance is felt. Allow Cable to retract fully and then pull it quickly. Repeat
until the engine starts.
6. Once the Engine is started, press the Choke down slowly to open it. If the
Engine does not start, press the Primer one more time. Raise the Choke if it is
pressed down, and again attempt to start the Engine.
7. Accelerate the Engine to full throttle just before starting to drill by squeezing the
Throttle. Keep the Engine at full throttle the entire time you are drilling, unless a
problem arises.
8. During drilling, periodically pull Auger up to remove loosened earth. If loosened
earth is allowed to remain in the drilled hole, the Auger will screw into the earth,
become stuck, and twist violently.
QUICK START GUIDE
For more information
on assembling this
product, scan the QR
Code to watch the
instructional video.
7
ASSEMBLY