GENERAL SAFETY WARNINGS
Read all safety warnings and instructions. Failure to follow the warnings and instructions may
result in electric shock, fire and/or serious injury. Save all warnings and instructions for future
reference.
The warnings, precautions, and instructions discussed in this instruction manual cannot cover all possible
conditions and situations that may occur. It must be understood by the operator that common sense and
caution are factors which cannot be built into this product, but must be supplied by the operator. Read
carefully and understand all
ASSEMBLY AND OPERATION INSTRUCTIONS
before operating. Failure to
follow the safety rules and other basic safety precautions may result in serious personal injury.
1
Use rebar cutters on concrete re-forcing bars only.
IMPORTANT SAFETY INFORMATION
Restrict use to designated materials.
There is always a chance that the cut end may shoot out, especially if less than 30cm in length. Exceeding
designated material specifications greatly increases this risk and will also damage the tool. Do not attempt
to cut rebars. Harder, thicker or thinner than those specified.
Use eye protection.
Wear safety goggles, safety glassed with side shields or a face shield when using
cutter.
Exercise proper control.
Hold cutter firmly and maintain proper footing and balance. Do not over-reach
when working in high place , secure cutter to scaffolding with a safety rope. Check that power cord is not
fouled and keep cord away from sharp edges and heat. Check that all adjusting wrenches have been
removed before using cutter.
Guard Against electric shock.
To avoid possible electric shock, do not handle cutter with wet hands or
use cutter in the rain or damp places. Be aware of all power lines, electric circuits and other hazards that
may be contacted, especially those that are below the surface or otherwise hidden from view.
Unplug the tool.
Disconnect cutter from outlet when not in use and before cleaning, adjusting or
servicing. Do not disconnect plug from outlet by pulling the cord. Always check that the switch lock if
OFF before plugging in.
Provide safety barriers.
Erect safety screens to protect co-workers from possible flying ends. Place
safety screen under the rebar when working in high places.
Beware of the environment.
Do not use cutter in the presence of flammable materials (e.g. Paint,
thinner, petroleum products, adhesives). Do not use cutter in a possibly lighted and clear of obstructions.
Operator should at all times have an unobstructed view of the cutter, rebar and surrounding area.
Wear proper apparel
SAVE THESE WARNINGS
Do not
wear loose clothes, dangling objects or jewellery. Restrain hair. The use of a safety-helmet and
rubber soled boots is ecommended . If safety gloves are worn, be especially careful that gloves does not
get caught in moving parts.
Maintain the cutter with care inspect the cutter before each application. Faulty or loose cutter blocks ould
result in personal injury. Keep handle dry, clean and free from il and/or grease. Keep housmg and piston
free of dirt and iron filings. Check that no screws or bolts are loose or missing. Inspect switch, cord,plug
and any extension cable at regular intervals.
Summary of Contents for 61084
Page 6: ...5 PARTS INFORMATION 61084 ...
Page 7: ...6 PARTS LIST ...
Page 8: ...7 PARTS INFORMATION 61085 ...
Page 9: ...8 PARTS LIST ...
