Xtreme Power Conversion Corporation
XSTi User’s Manual
Page 4
Uninterruptible Power Supply
Rear view
Installation & Initial Startup
Note:
Before installation, inspect the unit and packaging to make sure that nothing inside has been damaged.
Placement & Storage
Install the UPS in a protected area that is free of excessive dust and has adequate air flow. Place the UPS away
from other units at least 7.8 in (20 cm) to avoid interference. DO NOT operate the UPS where the temperature and
humidity is outside the specified limits. (See Specifications for details).
7.8 in
7.8 in
Connect UPS to Utility and Charging
Before the initial use of the UPS, plug the UPS input cord into a wall outlet and turn the UPS on by depressing the
Power switch on the front of the UPS. For best results, the batteries in the UPS should be charged for at least 8
hours before use. The UPS charges its battery while it is connected to AC utility power and powered on.
CAUTION: NEVER
connect a laser printer or scanner to the UPS. This may cause damage to the unit.
Connecting the Loads
Plug the loads to be supported by the UPS into the output receptacles on the rear of the UPS. Simply turn the
power switch on the UPS on and the devices connected to the UPS will be protected by the UPS unit.
Turn UPS ON / OFF
To turn the UPS unit on, press the Power switch on the front of the UPS. To turn the UPS unit off, press the Power
switch on the front of the unit again.
