Xtreme Power Conversion XPRT?1000, User And Installation Manual

Page: 12 / 49

XPRT ‐ 1000, XPRT ‐ 1500, XPRT ‐ 2000, XPRT ‐ 3000 USER’S MANUALUNINTERRUPTIBLE POWER SUPPLY (UPS)
[12]
ENTER BUTTON
Press this button to check the content of the UPS LDC display.
ON/OFF BUTTON
Press this button and hold for 3 seconds to turn the UPS on.
RS ‐ 232 Standard Interface
The RS ‐ 232 interface uses a 9 ‐ pin female D ‐ sub connector. Information provided includes data about
utility, load and the UPS. The interface port pins and their functions are identified in the following table:
PIN # SIGNAL NAME DIRECTION (RE: UPS) FUNCTIONS
2 TxD OUTPUT TxD OUTPUT
3 RxD INPUT RxD / INVERTER OFF INPUT
5 COMMON COMMON
6 OUTPUT AC FAIL OUTPUT
8 OUTPUT LOW BATTERY OUTPUT
9 OUTPUT 12VDC POWER
CAUTION: MAX RATED VALUES 12VDC
USB Port
Connecting the UPS to your computer is accomplished through the USB port on the back of your
computer. USB compliant hardware and operating system will be necessary, including installation of a
UPS driver. The serial port cannot be used when using the USB port. The USB cable is a standard cable
included.
Emergency Power Off (EPO) Port
A customer supplied switch located remotely can be used to open the EPO connection and allows the
UPS output receptacles to be switched off. Since the EPO shuts down the equipment immediately,
orderly shutdown procedures are not followed by any power management software. The UPS will have
to be manually restarted in order to regain power to the outlets on the UPS.
Network Transient Protector
The network transient protector located on the back panel of the UPS, has both an IN and OUT jacks,
housing a single RJ ‐ 45 (10BaseT) network connector. Connect the input connector to the jack labeled IN
and the output connector to the jack labeled OUT.